A wide is a delivery the umpire judges too far from the batter to be hit with a normal cricket stroke. Under Law 22 of the Laws of Cricket, it costs the bowling side one penalty run, it does not count as one of the six balls in the over, and the batters can still run or be out in a few specific ways. The basic test sounds simple, but where the batter is standing, whether the ball touched them, and which format you are watching all change the answer.
This guide explains the wide ball rule from the ground up: the Law itself, how Tests differ from ODIs and T20Is, the guideline lines you see painted on the pitch, and the ICC change that became permanent in international white-ball cricket from October 2026.
Key takeaways
- A wide is one penalty run plus any runs taken, all recorded as wides and charged to the bowler, and the ball must be re-bowled.
- It is not a wide if the ball touches the bat or batter, or if the batter’s own movement takes it out of reach.
- Off a wide, a batter can only be out stumped, run out, hit wicket or obstructing the field.
- White-ball cricket judges wides far more strictly than Tests, and since October 1, 2026, ICC uses the batter’s leg position at delivery as the reference point.
What Law 22 says: the basic test
The Marylebone Cricket Club (MCC), which writes the Laws, frames the wide around reach. If the bowler delivers a ball that is not a no-ball, the umpire calls it wide when it passes wide of where the striker is standing, and would also have passed wide of the striker standing in a normal batting position. The Law adds a useful working definition: a ball is wide unless it is sufficiently within the striker’s reach to be hit with a normal cricket stroke.
That two-part test is the heart of the rule. A wide has to be out of reach from where the batter actually is and from a normal stance. If either position puts the ball within reach, it is a fair delivery.
The 2022 change: batters who move early
Modern batters often walk across the crease, step towards leg or set up for a scoop before the ball is bowled. That created a problem. A bowler might aim at the batter, only to see them shuffle away and the ball called wide of their new position.
From October 1, 2022, the MCC amended Law 22.1 so that the umpire considers where the striker is standing, where they have stood at any point since the bowler began their run-up, and whether the ball would have been wide of a normal batting position. In plain terms: if the ball would have been within reach of a spot the batter occupied after the bowler started running in, it should not be a wide.
The best-known example came at the 2023 World Cup in Pune. With India needing two to win against Bangladesh and Virat Kohli on 97, Nasum Ahmed’s delivery slid down the leg side and umpire Richard Kettleborough did not signal wide. Many viewers assumed he was helping Kohli to a hundred. Wisden’s analysis pointed out that Kohli had been standing in an open, leg-side stance and moved again as the ball was bowled, so under the amended Law the “no wide” decision could be defended. Kohli hit a six two balls later to finish the match and reach his century.
When a wide is not a wide
Law 22 lists situations where the umpire must not call wide, or must take back a call already made:
- The ball touches the bat or the batter. If the striker gets any part of the bat or body on it, it is not a wide. A glove, pad or helmet counts.
- The batter’s movement causes it. If the striker moves and takes the ball out of reach, or moves and brings a wide-looking ball within reach, there is no wide.
- It is also a no-ball. The no-ball takes precedence. A delivery cannot be both, so a front-foot no-ball that sails past off stump is called a no-ball only.
The umpire calls and signals wide once the ball passes the striker’s wicket. The signal is both arms stretched out horizontally. The ball does not become dead because of the call, which is why runs and wickets are still possible.
Penalty, runs and the extra ball
Three things happen when a wide is called:
- One penalty run is added to the batting side’s total. It stands even if a batter is then dismissed.
- Any runs the batters complete, or a boundary, are also scored as wides, not byes, and none of it goes to the batter’s personal score. Wide runs are charged against the bowler’s figures.
- The ball does not count in the over. The bowler has to bowl an extra delivery.
| What happens after the wide | Runs added (all as wides) |
|---|---|
| Keeper collects it cleanly | 1 |
| Batters run two after a fumble | 3 |
| Ball runs away to the boundary | 5 (1 + 4) |
| Batter stumped off a wide | 1, and the batter is out |
That last row surprises a lot of fans. A batter can be stumped off a wide, and the penalty run still counts. It is why spinners sometimes push a ball wide outside off to a batter charging down the pitch: the extra run is a fair trade for a wicket.
How you can be out off a wide
Once wide is called, neither batter can be out except in four ways:
- Stumped: the striker is out of the crease and the keeper breaks the wicket.
- Run out: either batter, while trying to run.
- Hit wicket: the striker breaks their own stumps while reaching for the ball.
- Obstructing the field.
Bowled, caught and lbw are impossible off a wide. Since a wide, by definition, did not touch the bat or batter, a catch or an lbw could not happen anyway.
Tests vs ODIs and T20Is: why white-ball wides are stricter
The MCC Law gives umpires a lot of room. Professional competitions narrow it through their own playing conditions, and the ICC’s are much stricter in limited-overs cricket, where a bowler firing the ball out of reach would otherwise be a cheap way to stop runs.
| Situation | Test cricket (ICC) | ODIs and T20Is (ICC) |
|---|---|---|
| General approach | Reach-based test under Law 22, judged with more latitude | Strict interpretation, guided by lines on the pitch |
| Ball down the leg side | Wide only if out of reach, unless the umpire sees negative leg-side bowling | Usually wide, except in the zone between leg stump and the protected-area marker |
| Bowling into the rough outside leg | Strict white-ball interpretation applies | Strict interpretation applies |
| Ball passing over the batter’s head | Called wide if it passes above head height of the striker standing upright at the crease | Also covered by the playing conditions, alongside per-over limits on short-pitched balls |
| Batter shuffles across | Law 22.1, which considers where the batter has stood since the run-up began | Batter’s leg position at the moment of delivery is the reference point (from Oct 1, 2026) |
The wide guidelines on the pitch
In ODIs and T20Is you will see short white lines inside each return crease. These are the wide guidelines. The return creases are 4 feet 4 inches either side of middle stump, and the guidelines are marked 17 inches inside them. A ball passing outside the off-side guideline, with the batter in a normal stance, is a wide. The lines help umpires make quick, consistent calls, though the decision is still theirs.
The leg-side zone and the 2026 change
Leg-side wides used to be the harshest call in white-ball cricket: almost anything missing leg stump was signalled. In June 2025 the ICC announced a trial to help bowlers. A ball passing the popping crease between leg stump and the protected-area marker, which sits about a foot from the middle stump line, would no longer be a wide. The marker was extended to the popping crease so umpires could see it, and the trial started in ODIs and T20Is in October 2025.
The same package addressed shuffling batters by making the position of the batter’s legs at the point of delivery the reference for a wide. Under the ICC playing conditions that apply to international series starting on or after October 1, 2026, this approach is now permanent in ODIs and T20Is. A batter who walks across to off after the ball is bowled can no longer drag the wide line with them.
Practically, this rewards bowlers who target the stumps and penalises only the deliveries that really are out of reach. Expect fewer leg-side wides in death overs, where bowlers often aim yorkers at the pads.
Why wides matter more than they look
One run sounds trivial. It is not, for three reasons.
The extra ball. Every wide gives the batting side another delivery. In a T20 death over, that extra ball can easily be worth a boundary on top of the penalty run.
The free hit carries over. If a bowler oversteps, the next ball is a free hit. If that free-hit delivery is then called wide, the free hit stays in force for the next legal ball. Our free hit rule explainer covers this in detail.
Pressure and over rates. Wides lengthen overs, which matters when teams are racing the clock in a powerplay or trying to avoid over-rate penalties. A bowler who sprays two or three in an over also hands the initiative to the batters.
A quick checklist for club umpires and players
- Check your league’s playing conditions. Many club and age-group competitions adopt white-ball-style strictness on leg-side wides.
- Wait until the ball passes the striker’s stumps before signalling.
- Ask: did it touch bat or body? Did the batter’s movement cause it? Is it already a no-ball?
- Score every run off a wide as wides, not byes, and do not count the ball in the over.
- Batters: stay in your crease after a wide unless you mean to run, because stumpings still count.
What do you think? Join the discussion in our CricAmore forums and share your take with fellow fans.
Frequently asked questions
How many runs is a wide in cricket?
One penalty run, plus any runs the batters complete. If the ball goes to the boundary, five wides are scored. The ball also has to be bowled again.
Can a batter be out off a wide ball?
Yes, but only stumped, run out, hit wicket or obstructing the field. A batter cannot be bowled, caught or lbw off a wide.
Are wides counted against the bowler?
Yes. All runs scored from a wide, including the penalty run and any boundary, go into the bowler’s figures. Separate 5-run penalties for other offences are not charged to the bowler.
Is a ball down the leg side always a wide?
Not always. In Tests it depends on reach and whether the umpire sees negative bowling. In ICC ODIs and T20Is, a ball passing between leg stump and the protected-area marker is not a wide; anything wider down the leg side usually is.
Sources: ICC Test playing conditions, Clause 22, Wisden (2022 Law change), Wisden (ICC trial), Wisden (wide guidelines), Outlook India



1 Comment